PVC heating mats installation guide

STEP 1
Divide the floor area into a series of rectangles. From these measurements you can calculate how many mats you will need and what sizes. Exclude permanent or static fixtures from your calculations.
STEP 2
If the floor is screed over concrete, it is advisable to lay insulation boards to minimise heat loss and ensure quicker warm up times.
STEP 3
Lay the first run. At the end of the run cut the mat leaving the cable intact, turn the mat through 90º or 180º and continue laying. When the area is covered, adjust the mat until the loops are equal distance apart. Now attach the mat to the subfloor using the special tape supplied.
STEP 4
You will need to install an RCD fused spur which powers the thermostatic controller/programmer and the matting system heating element network.
STEP 5
Either lay a thin, self-levelling screed over the mat and leave it to dry before laying tiles or trowel flexible tile adhesive directly over the mat and lay the floor tiles. Once the grouting is complete, let the tile adhesive cure before switching on the system.
© Warmup | Electric Floor Heating MT 280
280